Magelis HMIS85 HMIS85W Touch Screen Glass Protective Film

Schneider Magelis HMIS85 HMIS85W HMIF85 Touch Screen Panel Glass Protective Film repair replacement

The Schneider HMIS85 HMIS85W operator panel has a power rating of 110VA and an input voltage range between 90 and 264 Volts AC at 47 to 63 Hertz line frequency, a current of 1.6 Amps at 100 Volts AC, and one of 0.67 Amps at 240 Volts AC. It uses panel mounting and has a NEMA Type 4 enclosure rating.

Schneider HMISCU System Architecture. Optimized configuration and flexibility is provided by the association of:
rear module that provides the logic and HMI functions
front module that provides the display feature
display module/rear module separation cable allows you to separate the display module from the rear module

ENVIRONMENTAL HAZARDS TO THE HMIS85 HMIS85W HMI，Allow the device to reach the surrounding air temperature, not exceeding 50 C (122 F), before turning the device on.
Do not turn on the device if condensation has occurred inside the device. After it is completely，and dry again, the device may be turned on. Do not expose the device to direct sunlight. Do not obstruct the vents in the device casing.Remove any dust from the device before turning it on. Ensure that the cable installation fasteners are not damaged. Replace them, if necessary. Mount the device into an enclosure that meets the IP65 level of protection

Specifications:

The table below describes the parameters of the HMIS85 HMIS85W touchscreen protective film.

PDF Download:

Magelis SCU Series Part No.